Table of Contents
Advertisement
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you fi nish all assembly steps.
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• To identify small parts, see page 5.
1. Go to www.proform.com/registration on your
computer and register your product.
• activates your warranty
• saves you time if you ever need to contact
Customer Care
• allows us to notify you of upgrades and offers
Note: If you do not have Internet access, call
1-888-533-1333 and register your product.
2. Identify the Rear Stabilizer (3), which has a
Leveling Foot (28) near each end.
Set a sturdy piece of packing material (not
shown) under the rear of the Frame (1).
Orient the Rear Stabilizer (3) as indicated by the
sticker. Attach the Rear Stabilizer to the Frame
(1) with two M10 x 68mm Screws (44).
Remove the packing material.
In addition to the included tool(s), assembly
requires the following tools:
one Phillips screwdriver
one adjustable wrench
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
2
3
28
44
28
6
1
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 831.21813.2 and is the answer not in the manual?
Questions and answers
Belt broke is it worth replacing ?
The manual provides instructions for adjusting the drive belt on the Pro-Form 831.21813.2 but does not mention replacing it. However, since the bike is covered by a 90-day full warranty and the frame has a 5-year warranty, it may be worth checking if the repair is covered. If the bike is out of warranty, replacing the belt could be worth it if the rest of the bike is in good condition and the cost of replacement is reasonable compared to buying a new bike.
This answer is automatically generated
How do you get the batteries out of the battery compartment? I cannot pull them out to change them. Please advise.