Table of Contents
Advertisement
9. Orient the Seat Post (10) as shown. Loosen the
Post Knob (18) a few turns, pull it outward, and
insert the Seat Post into the Frame (1).
Then, slide the Seat Post (10) upward or down-
ward to the desired position, and release the
Post Knob (18) into one of the adjustment holes
in the Seat Post. Move the Seat Post upward
or downward slightly to make sure that the
Post Knob is engaged in one of the adjust-
ment holes in the Seat Post. Then, tighten the
Post Knob.
10. See the inset drawing. Remove the Carriage
Knob (15) from the Seat Carriage (11).
Next, set the Seat Carriage (11) on the Seat Post
(10) and hold it in place.
Insert the Carriage Knob (15) upward into the
Seat Post (10), and tighten the Carriage Knob
into the Carriage Bracket (14) inside the Seat
Carriage (11). Make sure that the Carriage
Knob is tightened into the Carriage Bracket.
9
Adjustment
Holes
10
1
10
11
10
15
10
18
10
14
15
11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 831.21813.2 and is the answer not in the manual?
Questions and answers
Belt broke is it worth replacing ?
The manual provides instructions for adjusting the drive belt on the Pro-Form 831.21813.2 but does not mention replacing it. However, since the bike is covered by a 90-day full warranty and the frame has a 5-year warranty, it may be worth checking if the repair is covered. If the bike is out of warranty, replacing the belt could be worth it if the rest of the bike is in good condition and the cost of replacement is reasonable compared to buying a new bike.
This answer is automatically generated
How do you get the batteries out of the battery compartment? I cannot pull them out to change them. Please advise.
To remove the batteries from the battery compartment of the Pro-Form 831.21813.2, first remove the screws and the battery covers. Then take out the batteries from the battery compartments.
This answer is automatically generated