ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench _
and Phillips
screwdriver _.
Use the part drawings below to identify the small parts used in assembly. The number in parentheses below
each drawing refers to the key number of the part, from the PART LIST on page 18. The second number refers
to the quantity needed for assembly. Note: Some small parts may have been pre-attached
for shipping.
If a
part is not in the parts bag, check to see if it has been pre-attached.
If a part is missing, call toll-free
t-888-533-t 333.
M8 Nylon
Locknut (37)-4
M8 Split
M10 Split
M4 x 22ram
Washer (36)-4
Washer (34)-3
Screw (15)-2
M10 x 20mm Button
Screw (35)-3
M4 x 16ram
Screw (41)-4
M10 x 74ram Button Screw (33)-4
1. Identify the Front Stabilizer (2), which is narrower than
the Rear Stabilizer (not shown). While another person
lifts the front of the Frame (1), attach the Front
Stabilizer to the Frame with two M10 x 74ram Button
Screws (33).
2
33
4
Need help?
Do you have a question about the XP 100 U and is the answer not in the manual?