Table of Contents
Advertisement
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user's authority to operate this equipment.
18
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 831.21813.2 and is the answer not in the manual?
Questions and answers
Belt broke is it worth replacing ?
The manual provides instructions for adjusting the drive belt on the Pro-Form 831.21813.2 but does not mention replacing it. However, since the bike is covered by a 90-day full warranty and the frame has a 5-year warranty, it may be worth checking if the repair is covered. If the bike is out of warranty, replacing the belt could be worth it if the rest of the bike is in good condition and the cost of replacement is reasonable compared to buying a new bike.
This answer is automatically generated
How do you get the batteries out of the battery compartment? I cannot pull them out to change them. Please advise.
To remove the batteries from the battery compartment of the Pro-Form 831.21813.2, first remove the screws and the battery covers. Then take out the batteries from the battery compartments.
This answer is automatically generated