Table of Contents
Advertisement
3. Set a sturdy piece of packing material under the
front of the Frame (1).
Orient the Front Stabilizer (2) as indicated by the
sticker. Attach the Front Stabilizer to the Frame
(1) with two M10 x 68mm Screws (44).
Remove the packing material.
4. Orient the Upright (4) as shown.
Tip: Avoid pinching the Main Wire (41). Attach
the Upright (4) to the Frame (1) with four M8 x
18mm Screws (42).
Locate the wire tie in the Upright (4). Tie the
lower end of the wire tie to the Main Wire (41).
Then, pull the upper end of the wire tie until the
Main Wire is routed through the Upright.
Tip: To prevent the Main Wire (41) from fall-
ing into the Upright (4), secure the Main Wire
with the wire tie.
Insert the excess Main Wire (41) into the
Upright (4).
3
4
Wire Tie
Avoid pinching the
Main Wire (41)
Wire Tie
7
44
2
1
4
42
42
41
1
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 831.21813.2 and is the answer not in the manual?
Questions and answers
Belt broke is it worth replacing ?
The manual provides instructions for adjusting the drive belt on the Pro-Form 831.21813.2 but does not mention replacing it. However, since the bike is covered by a 90-day full warranty and the frame has a 5-year warranty, it may be worth checking if the repair is covered. If the bike is out of warranty, replacing the belt could be worth it if the rest of the bike is in good condition and the cost of replacement is reasonable compared to buying a new bike.
This answer is automatically generated
How do you get the batteries out of the battery compartment? I cannot pull them out to change them. Please advise.
To remove the batteries from the battery compartment of the Pro-Form 831.21813.2, first remove the screws and the battery covers. Then take out the batteries from the battery compartments.
This answer is automatically generated