Advertisement
Table of Contents
- 1 Warning Decal Placement
- 2 Important Precautions
- 3 Before You Begin
- 4 Part Identification
- 5 How to Use the Exercise Bike
- 6 Console Diagram
- 7 Features of the Console
- 8 How to Use the Manual Mode
- 9 The Settings Mode
- 10 Fcc Information
- 11 Maintenance
- 12 Console Troubleshooting
- 13 Exercise Guidelines
- 14 Part List
- 15 90 Day Full Warranty
- Download this manual
Advertisement
Table of Contents
Need help?
Do you have a question about the 460R and is the answer not in the manual?
Questions and answers
replaced batteries and no power up response after pedaling up. Can you advise? Unit incline 460R smr proform incline bicycle
If the Pro-Form 460R does not power up after replacing the batteries, begin pedaling. The bike does not require a power cord and powers on when you start pedaling.
This answer is automatically generated
how to remove the pedal crank arm?
To remove the pedal crank arm on a Pro-Form 460R:
1. Using an adjustable wrench, turn the Right Pedal (29) counterclockwise to remove it.
2. Use a flat screwdriver to release the tabs around the edge of the right Lock Ring (23) and remove it from the Right Shield (22).
3. Once the Drive Belt (59) is tight, tighten the Adjustment Screw (47).
4. Remove the Rear and Front Upright Covers (19, 20) by removing the two M4 x 12mm Screws (57).
5. Reattach the necessary parts after removal.
Note: The crank arm itself is not directly mentioned, but these steps involve removing the pedal and surrounding components, which may be necessary for crank arm removal.
This answer is automatically generated
Dont see the pedal crank arm in the parts list
The pedal crank arm is part of the "Crank/Pulley" assembly, which is listed as item 40 in the parts list for the Pro-Form 460R.
This answer is automatically generated
where do you change the battery
To change the battery on a Pro-Form 460R, unscrew the latch behind the display screen and replace the old batteries with heavy-duty alkaline D batteries.
This answer is automatically generated
my grandkids played with my bike and now the resistance is to strong for me. Everything is reset to 0-1 but still strong resistance when I try to pedal. Is there some kind of adjustment I need to do?