Symptoms - McCulloch ROB R600 Operator's Manual

Light
Blue flashing light
Yellow flashing light
Red flashing light
Solid blue light
Solid red light

Symptoms

If your robotic lawnmower does not work as expected, follow the troubleshooting guide below.
There is a FAQ (Frequently Asked Questions) on www.mcculloch.com which provides more detailed answers to a num-
ber of standard questions. Contact your local McCULLOCH representative if you still cannot find the reason for the fault.
Symptoms
The robotic lawnmow-
er has difficulty dock-
ing.
175 - 001 - 17.03.2017
Cause
The boundary loop is not connected to the
charging station
Break in the boundary loop
The guide wire is not connected to the charging
station
Break in the guide wire
Interruption in the charging station's antenna
Weak signal as the boundary wire is too long.
Max length is 400 m.
Fault in the circuit board or incorrect power
supply in the charging station. The fault should
be rectified by an authorized service technician.
Cause
The boundary wire is not laid in a long straight
line that is far enough out from the charging
station.
The guide wire is not inserted in the slot at the
bottom of the charging station.
The charging station is on a slope.
Action
Check that the boundary wire connector is fit-
ted properly to the charging station. See
necting the boundary wire on page 18 .
Find out where the break is. Replace the dam-
aged section of the boundary wire with a new
loop wire and splice using an original coupler.
Finding breaks in the loop wire on page
See
43 .
Check that the guide wire connector is properly
connected to the charging station. See
and connecting the guide wire on page 19
Find out where the break is. Replace the dam-
aged section of the guide wire with a new loop
wire and splice using an original coupler.
Contact your local McCULLOCH representa-
tive.
No steps have to be taken if the robotic lawn-
mower operates as expected.
Shorten the boundary wire by reducing the
working area or replacing islands with barriers
the robotic lawnmower can collide with.
Contact your local McCULLOCH representa-
tive.
Action
Check that the charging station has been in-
stalled according to the instructions in
the boundary wire on page 17
It is absolutely critical for operation that the
guide wire is perfectly straight and is in the cor-
rect position under the charging station. There-
fore make sure that the guide wire is always in
its slot in the charging station. See
connecting the guide wire on page 19 .
Place the charging station on a surface that is
Charging station on page 10 .
entirely level. See
Con-
Laying
Laying
Laying and
41