Charging A Flat Battery; Timer And Standby - McCulloch ROB R600 Operator's Manual

WARNING! Never use the robotic lawnmower
when persons, especially children, or pets, are in
the cutting area.
Set the main switch in the
lawnmower.
Set the main switch in the
lawnmower is not in use or work is being carried out on the
blade disc.
When the main switch is set in the
the robotic lawnmower cannot start.

Charging a flat battery

When the McCULLOCH robotic lawnmower is new or has
been stored for a long period, the battery will be flat and
needs to be charged before starting. Charging takes
approximately 80 to 100 minutes.
1. Set the main switch to position
2. Park the robotic lawnmower in the charging station.
Open the hatch and slide the robotic lawnmower in as
far as possible to ensure proper contact between the
robotic lawnmower and the charging station.
3. The display shows a message that charging is in
progress.

Timer and Standby

Use the timer function (see
downtrodden lawn.
Standby
The robotic lawnmower has an inbuilt standby period
according to the Standby time table. The standby period
provides for instance a good opportunity to water or play
games on the lawn.
175 - 001 - 17.03.2017
1 position to start the robotic
0 position when the robotic
0 position the motors on
1 .
Timer on page 23 ) to avoid a
Model
McCULLOCH ROB R600
McCULLOCH ROB R1000
Setting the timer
When setting the timer, calculate that the robotic
lawnmower mows about the amount of the number of
square meters per hour and day listed in table Work
capacity.
Model
McCULLOCH ROB R600
McCULLOCH ROB R1000
If the working area is for example 360 m
R1000 must operate for 7,5 hours a day. The times are
approximate and depend for instance on grass quality,
blade sharpness and battery age.
WARNING! Use the timer to avoid mowing when
there are usually children, pets and anything else
that could be damaged by the rotating blades on
the lawn.
The factory setting for the timer is 07:00-23:00 and it
allows mowing every day of the week. This setting is
suitable for the listed maximum working area.
If the size of the working area allows it, the quality of the
grass can be further improved if it is cut every other day
instead of a few hours every day. In addition, the grass
benefits from resting completely during at least a three-day
period once a month.
Example 1
The times used in this example are applicable to ROB
R600, but the principle is the same for other models.
Work period 1: 07:00 - 23:00
Work days: All days.
The factory setting ensures that the robotic lawnmower
begins cutting the lawn at 07:00. The mower is parked in
the charging station from 20:00 and rests until it starts
cutting again at 07:00.
If the timer setting is divided into two work periods, the
standby period can be divided into a number of periods.
The minimum standby period time must however be a
according to the Standby time table.
Standby time
At least 11 hours per day
At least 4 hours per day
Work capacity
2
About 43 m per hour and
day
2
About 48 m per hour and
day.
2
in size, ROB
33