McCulloch ROB R600 Operator's Manual page 41

Message
Low battery / Empty
battery
Wrong PIN
Wheel motor overloa-
ded,right
Wheel motor overloa-
ded, left
No drive
Charging station
blocked
Stuck in charging sta-
tion
Upside down
Needs manual charg-
ing
175 - 001 - 17.03.2017
Cause
The robotic lawnmower cannot find the charg-
ing station.
The guide wire is broken or not connected.
The battery is spent.
The charging station's antenna is defective.
Wrong PIN code has been entered. Five at-
tempts are permitted, and the keypad is then
blocked for five minutes.
The robotic lawnmower has got caught in
something.
The robotic lawnmower has got caught in
something.
The working area includes a steep slope.
The guide wire is not laid at an angle on a
slope.
The contact between the charging strips and
contact strips may be poor and the robotic
lawnmower has made a number of attempts to
charge.
An object is obstructing the robotic lawnmower. Remove the object.
The charging station is tilted or bent.
There is an object in the way of the robotic
lawnmower preventing it from leaving the
charging station.
The robotic lawnmower is leaning too much or
has turned over.
The robotic lawnmower is set in the
ating mode.
Action
Check that the charging station and the guide
wire are installed in accordance with the in-
structions in
page 18 .
Check that the indicator lamp in the charging
station flashes yellow. See the solution in,
cator lamp in the charging station on page 40 .
Replace the battery. See
on page 36 .
Check if the indicator lamp in the charging sta-
tion flashes red. See
charging station on page 40 .
Enter the correct PIN code. Contact your local
McCULLOCH representative if you forget the
PIN code.
Free the robotic lawnmower and rectify the rea-
son for the lack of drive. If it is due to wet
grass, wait until the lawn has dried before using
the robotic lawnmower.
Free the robotic lawnmower and rectify the rea-
son for the lack of drive. If it is due to wet
grass, wait until the lawn has dried before using
the robotic lawnmower.
Maximum guaranteed slope is 25%. Steeper
slopes should be isolated. See
16 .
If the guide wire is laid on a slope, it must be
laid at an angle across the slope. See
tion of the guide wire on page 18
Put the robotic lawnmower in the charging sta-
tion and check that the charging strips and con-
tact strips make good contact.
Confirm that the charging station is placed on a
fully flat and horizontal ground. The charging
station must not be tilted or bent.
Remove the object.
Turn the robotic lawnmower the right way up.
MAN oper-
Place the robotic lawnmower in the charging
station. This behaviour is normal and no action
is required.
Installation of the guide wire on
Replacing the battery
Indicator lamp in the
Slopes on page
Indi-
Installa-
39