McCulloch ROB R600 Operator's Manual page 17

CAUTION! The robotic lawnmower must never run
over gravel, mulch or similar material which can
damage the blades.
CAUTION! If the working area is adjacent to water
bodies, slopes, precipices or a public road, the
boundary wire must be supplemented with an
edging or the like. It must then be at least 15 cm in
height. This will prevent the robotic lawnmower
from ending up outside the working area under
any circumstance.
Boundaries within the working area
Use the boundary wire to demarcate areas inside the
working area by creating islands around obstacles which
cannot withstand a collision, for example, flowerbeds,
bushes and fountains.
0 cm / 0"
Obstacles that can withstand a collision, for example, trees
and bushes higher than 15 cm, do not need to be
demarcated by the boundary wire. The robotic lawnmower
will turn around when it collides with this type of obstacle.
175 - 001 - 17.03.2017
Min. 15 cm / 6"
However, to achieve careful and silent operation, it is
recommended to isolate all fixed objects in and around the
working area.
Lay the wire up to and around the area to be demarcated,
and then return it back along the same route. If pegs are
used, the wire should be laid under the same peg on the
return route. When the boundary wires to and from the
island are laid close together, the robotic lawnmower can
drive over the wire.
Note: The boundary wire may not be crossed on its way to
and from an island.
0 cm/0"
Obstacles that slope slightly, for example, stones or large
trees with raised roots, must be isolated with an island or
removed. Otherwise the robotic lawnmower can slide up
onto this kind of obstacle causing the blades to be
damaged and/or the mower to get stuck.
Level the lawn and remove holes/hollows in the working
area to avoid pools of water in case of heavy rain.
Secondary areas
If the working area consists of two areas which the robotic
lawnmower has difficulty travelling between, it is
recommended to set up a secondary area. Instances of
this are 25% slopes or a passage that is narrower than 60
cm. Lay the boundary wire then around the secondary
area so that it forms an island outside of the main area.
The robotic lawnmower must be moved manually between
the main and secondary area when the lawn in the
secondary area has to be cut. The
must be used as the robotic lawnmower cannot travel on
its own from the secondary area to the charging station.
Operation selection on page 32 . In this mode, the
See
robotic lawnmower will never look for the charging station
but will mow until the battery runs out. When the battery is
MAN operation mode
15