McCulloch ROB R600 Operator's Manual page 13

3 m / 10 ft
2 m / 7 ft
Do not put the charging station in confined spaces in the
working area. There must be a straight boundary wire, at
least 1.5 m long, to the right and left of the charging
station. The wire must be laid straight out from the rear
end of the charging station. Any other locations can mean
that the robotic lawnmower enters the charging station
sideways and will have difficulty docking.
Do not put the charging station in a corner in the working
area. There must be a straight boundary wire, at least 1.5
m long, to the right and left of the charging station.
The charging station must be positioned on relatively level
ground. The front end of the charging station must be a
maximum of 3 cm higher than the back end. The front end
of the charging station must never be lower than the back
end.
Max 3 cm / 1.2"
The charging station must not be positioned in a way that
can bend its base plate.
175 - 001 - 17.03.2017
If the installation is done in a working area with a steep
slope (such as around a house on a hill), the charging
station should be placed in the area at the bottom of the
slope. This makes it easier for the robotic lawnmower to
follow the guide wire to the charging station.
The charging station should not be placed on an island as
this limits the laying of the guide wire in an optimal way. If
the charging station has to be installed on an island, the
guide wire also has to be connected to the island. Read
more about islands in chapter
working area on page 15 .
Connecting the power supply
Take the following into consideration when planning where
to place the power supply:
• Close to the charging station
• Protection from rain
• Protection from direct sunlight
If the power supply is connected to an electrical socket
outdoors, this must be approved for outdoor use.
No parts of the power supply must be changed or
tampered with. For example the low voltage cable must
Boundaries within the
11