Table of Contents
Advertisement
ADASH Ltd.
RUN 1
amplitude of RUN 1
Effect
the reduction of balancing in % (the 1.1mm/s is 91.2% less than 12.5 mm/s)
Quality
balancing quality factor according to ISO 1940 (mass of rotor and radius of balancing required)
If the rotor settings are entered then the Quality factor is displayed instead of Effect. Press the
Shift button and the Effect will be displayed.
Trim Screens
If you are not satisfied with the results then you can continue the balancing job after the RUN 3 measurement
(press the right arrow button). These next steps do not require the trial mass measurements anymore. After
each reading the next mass (or masses) is recommended. The trim screens are very similar to the screens
described before.
The recommended trim mass is displayed. After mounting the trim mass, press the right arrow button.
The TRIM 1 screen appears. It is the same screen as the RUN 3 screen. Run the measurement or enter the
values.
Then the new results, effect and quality value are displayed.
Press the right arrow and continue with TRIM 2 in same way as with TRIM 1. You can use as many trims as you
want. However, when the trim result is not better (or even is worse) it makes no sense to keep trimming.
Dual plane balancing
RUN 1 screen
The screen is divided into two parts. The upper part corresponds to Point A and the lower one to Point B.
If you use only one sensor, then only one part is selected (red border). The other part is bordered in grey. Mount
the sensor to the selected point and take the reading. Use the up/down arrow buttons to change the selection
of the Point. Do the same for the second point.
With two sensors you take both points readings at once.
You can also enter the values manually.
For further technical and contact information visit www.adash.com, email: info@adash.cz
52
Adash 4300 – VA3Pro
Advertisement
Table of Contents
