Understanding Rear Panel Leds And Buttons - HPE D6020 User Manual

Understanding rear panel LEDs and buttons

Figure 4 Rear panel LEDs and buttons
Table 4 Rear panel LED and button descriptions
Item Description
1 Power On/Standby button and
system power LED
2 Internal Health LED
3 GSI LED
4 UID button/LED (Drawer 2)
5 Power supply LED
6 System fan LED
8 Component identification
1
Status
Green = On
Amber = Standby (auxiliary power present)
Off = Off
Green = System health is good.
Off = System is off.
Amber = Enclosure requires a service check. Check the I/O
module, fan and power supply LEDs, and AC power cables to
power supplies.
Off = Enclosure is functioning normally.
Blue = UID LED is enabled from the UID button.
Blue solid = System is in hard drive Locate mode or an enclosure
firmware update is in progress.
Off = UID LED is disabled.
Green = Power on and power supply functioning properly
Off = One or more of the following conditions exists:
System powered off
AC power unavailable
Power supply failed
Power supply exceeded current limit
Green = Normal operation
Amber flashing = Fault
Off = Fan unseated from connector or failed