HPE D6020 User Manual page 15

Figure 7 Aligning the back of the chassis with the rails
WARNING! The chassis is very heavy. To reduce the risk of personal injury or damage
to the equipment:
Be sure that the rack is adequately stabilized before installing the chassis.
Always use either a lift that can handle the load of the product or get at least four people
to lift and stabilize the product during assembly, installation, or removal, especially if
the chassis is not installed in the rack. An additional person may be required to help
align the chassis if the chassis is installed higher than chest level.
Observe local occupational health and safety requirements and guidelines for manual
material handling.
HPE recommends that you note the location of each hard drive in each drawer, and
then remove all hard drives from the hard drive drawers before moving the D6020.
CAUTION: Be sure to keep the product parallel to the floor when installing the chassis.
Tilting the product up or down could result in damage to the rails.
3. Set the chassis securely on the left and right rack rails, and then slide the chassis on the
rack rails toward the back of the rack, releasing the handles, as appropriate, just before they
contact the rack rails. Be sure to slide the chassis into the rack until it is fully seated inside
the rack and on both rack rails.
Figure 8 Sliding the chassis into the rack and tightening the thumbscrews
4. Tighten the thumbscrews on each side of the front of the chassis (see
into the rack and tightening the thumbscrews" (page
5. Position the retaining brackets (1) to each side of the rear of the disk enclosure and secure
the brackets to the rack.
"Sliding the chassis
15).
Installing the chassis in the rack 15