IMPORTANT:
To power down the D6020:
1.
Power down the partner nodes. See the node documentation for additional details.
2.
Press and hold the Power On/Standby button for approximately 4 seconds. This action
powers down both hard drive drawers.
NOTE:
If the D6020 is powered down, note that all LEDs, except for the Power On/Standby
button LED, turn off. While in Standby mode, the Power button glows amber. If the entire system
is fully powered off, all LEDs are off.
26
Operating the system
If installing a hot-plug device, it is not necessary to power down the D6020.