4)
Put the shorter
side of the wire @
through under mirror 1 mount @ and the
mirror 2 and 3 mount 8, then hook it on
the pulley @ at the left rear side and pul-
ley @ of the mirror 2 and 3 mount.
0
Figure 4-216
5)
After hooking the shorter side of the wire
@ on the wire hook @, use adhesive
tape ($ to secure the rear end of the
wire on the left side face. Arrange the
securing position of the wire so that, as
shown in the Figure below, the rear end
of the wire comes to the position against
the hole on the left side face.
Figure 4-217
4-10
COPYRIGHT 0
1495 CANONINC.
6)
Hook the longer side of the wire @ on
the ,pulley @ at the right hand front side
as shown in the Figure below by routing
it along the wire drive pulley 0.
7)
Figure 4-218
Put the longer
side
of the wire
@
throught
under mirror 1 mount @ and
mirror 2 and 3 mount @I, then hook it on
the~pulley @I at the left hand front side
and pulley 0 of mirror 2 and 3 mount.
Figure 4-219
CANON NP60121NP6012F~NP6212
REV.1 SEP61995 PRlNTEOINJAPAN(IMPRIMC:AUJAPON)