Canon NP6012F Service Manual page 128

~ 3)
After making the adjustment, record the
new setting on the service label attached
behind the control panel.
Figure 3-814
4)
12.
After making the adjustment, execute
user mode 'U7'. (This step applies only if
the machine is equipped with the drum
unit replacement time automatic indica-
tion function.)
Adjust the Original Leading Edge
Stop Position
You must first correct original skew and
adjust the rear/front original stop position
before adjusting the original leading edge
stop position.
1) Obtain a sheet of A4 or LTR white copy
paper, and draw two lines as indicated.
l
The sheet will be used as a test chart.
WlOmm
fl
I
I
2
l-----l
A4/LTR copy napper
2) Remove the screw, and remove the ADF
controller cover.
DF controller cover
Figure 3-816
3) Turn on the copier, and place the test
chart prepared in step 1) 'on the original
tray.
Figure 3-817
Figure 3-815
-
3 - go
COPYRIGHT 0 1995 CANONINC. CANON NP6012/NP60i2FfNP6212 REV.I SEPT.1995 PRlNTEDINJAPAN(IMPAIM~AUJAPON)