Canon NP6012F Service Manual page 134

7. Filling Out the Service Label
Figure 7-4 shows the label attached
behind the front upper cover. Each machine
is adjusted and set at the factory, and the
settings are recorded on the label.
You must correct the settings recorded
on the label whenever you have entered
new settings.
If you have replaced the DC controller,
be sure to enter the settings recorded on the
label. Further, if you have replaced the com-
posite power supply PCB or the pre-expo-
sure lamp, you must enter the settings
recorded on the label attached to the service
label and copy the settings to the service
label.
I
lOPERATIONS AND TIMING
Figure 3-904
3 - 96
COPYRIGHT 0 1995 CANONINC. CANON NPE412/NP6012F/NP6212 REV.1 SEPT.1995 PRlNTEDINJAPAN(IMPRIM~AlJJAPON)