Binary Output Of Customized - HEIDENHAIN TNC 151 Q Mounting Instructions

9.8 Binary output of customized macros for programming a PLC-EPROM
Customized macros are output in binary with the PLC-program.
Data is output in the following sequence:
.PLC-program
.Macro-programs
.Dialogue texts
(for PLC-error messages and customized macros)
.Custom ized macros
After output of the dialogue texts, the following dialogue is displayed:
READ-OUT ALL PROGRAMS?
If all programs are to be read-out:
m
ENT
All macro programs within the EPROM and RAM
v
are output. If a program within the EPROM has the
same number within the RAM, the program within
the RAM is output.
If only certain programs are to be
read-out:
OUTPUT = ENT / END = NO ENT
99999970 99999982 99999993
99999995
In the program menu only those programs
V
are displayed which are stored within the
li""l ENT
EPROM
Transfer selected program onto tape
0uwuT =
ENT / END = NO ENT
99999970 99999982 99999993
99999995
The cursor is set to the next program
number
Should data output from the EPROM
)m Lastly, the control reads out the customized
be completed
w
macros from the RAM
PLC-EDITING FUNCTION
The controt returns to the mode
PLC-EDITING FUNCTION
92