Repair; 4I, 60-Cm Iv Induction - Siemens EH70650 Repair Instructions

6

REPAIR

6.1

4i, 60-cm IV Induction

6.1.1 Disassembly of the appliance:
►
Remove the cooktop plate, thereby taking care not to damage
the installation pins.
►
Place the cooktop plate on the counter with the glass side
down. Be careful not to damage it.
►
Remove the 12 screws that fasten the frame/glass to the base
►
Position the frame/glass unit with the glass up.
6.1.2 Assembly of the appliance:
►
Fasten the frame/glass unit to the base using 12 screws.
►
Install the plate on the cooktop, thereby taking care not to
damage the installation pins.
Attention!
The power connections of the inductors are made using a ring lug and
a metric thread screw. Tighten the screw until the terminal cannot be
turned by hand. If the screw thread becomes stripped, the induction
electronics board will be useless.
206_58300000105199_ara_en_h – 15.03.a Seite 46 von 66