Fan; Left Induction Electronics (Elin-Left) - Siemens EH70650 Repair Instructions

4.6

Fan

4.6.1 Overview
The fan that is installed uses direct current (brush-less), and it
contains electronic components in its interior.
It is connected to the ELIN DCHA board by a 3-wire connection, with
one of the ends welded to the printed circuit of the fan.
+24V
GND = ground
TACHO = tachometer
206_58300000105199_ara_en_h – 15.03.a
4.7

Left induction electronics (ELIN-left)

4.7.1 Overview
The new induction electronics integrates all the electronic components
that are associated with the dual, 280-mm element and that, in the
previous generation, were divided between the power board, the
control board and the filter board.
The interior zone and the exterior zone are treated as two different
cooking zones as regards the cabling.
Caution!
The ELIN-IZDA board for the 280 dual element is identical to the one
used in the 4I's, but it incorporates different software and has a
different material code.
The ELIN-IZDA board also contains the only power supply source of
the cooktop.
The induction electronics board communicates with the TC through
LIN communications. The TC sends the power level orders of each
burner, and the induction electronics returns the status of the burner
(container detection, errors, etc.).
4.7.2 Assembly
The left induction electronics (ELIN-IZDA) are fastened to the base
using two screws.
4.7.3 Components
Basically, the induction electronics board consists of the following
systems:
Seite 15 von 66