210 + 150 right inductor unit
The inductor unit contains the inductors corresponding to heating
elements 3 and 4. It is fastened to the support base using four holes,
where the 4 mounts of the support base are inserted.
The inductors transform the high-frequency alternating current into a
variable magnetic field.
The inductors contain two NTC sensors that measure the temperature
of the inductor and protect it against excessive temperatures.
Moreover, they serve to measure the temperature at which the
residual heat indicators turn on.
The mica sheets serve as electrical insulation between the inductor
and the glass. These sheets are installed without glue, wherefore
they can be replaced in the event that they become damaged.
Fastened on 4 mounts of the base using 4 helicoid springs and
connected to the ELIN-RIGHT electronics board.
206_58300000105199_ara_en_h – 15.03.a
Seite 12 von 66