Sensors, from left to right, in the YL 160-31(4i Ne):
Touch Control YL160 (Neff)
In induction cooktops, only the sensor and display board of the TC is
used. The power supply is obtained from the induction modules.
The TC board communicates with the induction electronics boards by
serial communications based on LIN protocol (Local Interconnect
Network). The connection is made by a 4-wire cable.
There is another connection for the technical service connector.
Cooktops with touch control have the control zone marked on the
glass surface. The capacitive sensors are located underneath these
Sensors, from left to right, in the YL 160-30 (2i Ne)
206_58300000105199_ara_en_h – 15.03.a
Seite 29 von 66