Switching Push-Assistance Mode On/Off; Pas Level Selection; Battery Indicator; Quality Assurance And Warranty Scope - Key-Disp KD26E User Manual

◆Switching Push-assistance mode On/Off

To access the push-assistance mode, hold the DOWN button always, the eBike will
go on at a uniform speed of 6 Km/h. Three power-assistance level indicator lights flash at
the same time.
The push-assistance function switches off as soon as you release the DOWN
button.
■
Push-assistance function may only be used when pushing the eBike. Danger of
injury when the wheels of the eBike do not have ground contact while using the
push-assistance function.

◆PAS Level Selection

Assistance level indicates the output power of the motor. The default value is level "1".
Press the UP/DOWN button to select power assistant level, the default power ranges
from level "0" to level "3". The output power is zero on Level "0". Level "1" is the minimum
power. Level "3" is the maximum power.

◆Battery Indicator

The five battery bars represent the capacity of the battery. The four green lamps are
lighting when the battery is in high voltage. When the battery is in low voltage, the left
lamps will be red to notice that the battery needs to be recharged immediately.
Operation Cautions
Be careful of the safety use. Don't attempt to release the connector when battery is
on power.
●
Avoid the risk of collision.
●
Don't modify system parameters to avoid parameters disorder.
●
Make the display repaired when error code appears.

Quality assurance and warranty scope

Ⅰ Warranty
1) The warranty will be valid only for products used in normal usage and conditions.
2) The warranty is valid for 24 months after the shipment or delivery to the customer.
Ⅱ Other items
The following items do not belong to our warranty scope.
1) The display is demolished.
2) The damage is caused by wrong installation or operation.
3) Shell of the display is broken when the display is out of the factory.
4) Wire of the display is broken.
5) Beyond warranty period.
6) The fault or damage is caused by the force majeure (such as fire, earthquake, etc,)
or natural disasters like lighting, etc.

Connection layout

Connector line sequence:
3