2.5 I Change to cooling mode
2.5.1 Connecti on to be made to change to cooling mode
The device operates either in heati ng mode or in cooling mode.
By default, the heat pump is in heati ng mode; to change to cooling mode, install a shunt between terminals 19 and 30
on the terminal unit. The device must then display
2.5.2 Adjusti ng the temperature setpoint (in cooling mode)
The setpoint temperature is set by default to 28°C.
• Press
+
for 5 seconds:
• Go to
then press
• Go to the
parameter, press
• Go to
(= cooling mode setpoint), press
• Set the value you want with
• Press
to exit.
The heat pump stops automati cally when the pool reaches the required temperature.
in place of
then press
to confi rm,
,
,
or
, then press
to confi rm.
.
to confi rm,
EN
9