Networkservices Snmp Communityname; Networkservices Snmp Host [1..3] Address; Networkservices Snmp Mode; Networkservices Snmp Systemcontact - Cisco DX70 Administrator's Manual

Cisco DX70 and DX80

Introduction

NetworkServices SNMP Mode

SNMP (Simple Network Management Protocol) is used in network management systems
to monitor network-attached devices (routers, servers, switches, projectors, etc) for
conditions that warrant administrative attention. SNMP exposes management data in the
form of variables on the managed systems, which describe the system configuration. These
variables can then be queried (set to ReadOnly) and sometimes set (set to ReadWrite) by
managing applications.
Requires user role: ADMIN
Default value: ReadOnly
Value space: Off/ReadOnly/ReadWrite
Off: Disable the SNMP network service.
ReadOnly: Enable the SNMP network service for queries only.
ReadWrite: Enable the SNMP network service for both queries and commands.

NetworkServices SNMP Host [1..3] Address

Define the address of up to three SNMP Managers.
The system's SNMP Agent (in the codec) responds to requests from SNMP Managers (a PC
program etc.), for example about system location and system contact. SNMP traps are not
supported.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 255)
A valid IPv4 address, IPv6 address or DNS name.
D15362.02 DX70 and DX80 Administrator Guide CE8.3, JANUARY 2017.
Configuration Peripherals Maintenance

NetworkServices SNMP CommunityName

Define the name of the Network Services SNMP Community. SNMP Community names
are used to authenticate SNMP requests. SNMP requests must have a password (case
sensitive) in order to receive a response from the SNMP Agent in the codec. The default
password is "public". If you have the Cisco TelePresence Management Suite (TMS) you
must make sure the same SNMP Community is configured there too. NOTE: The SNMP
Community password is case sensitive.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 50)
The SNMP community name.

NetworkServices SNMP SystemContact

Define the name of the Network Services SNMP System Contact.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 50)
The name of the SNMP system contact.

NetworkServices SNMP SystemLocation

Define the name of the Network Services SNMP System Location.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 50)
The name of the SNMP system location.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
83
Administrator Guide
System settings System settings Appendices