Cisco DX70 Administrator's Manual page 54

Cisco DX70 and DX80

Introduction
Factory reset the video system
We recommend that you back up the log files and configuration of the
video system before you continue with the factory reset.
Factory reset DX80 using the mute and volume
buttons
Follow these steps to factory reset a DX80 on boot up. If the video system
is on, press and hold the power button until the system shuts down before
you continue.
1. Locate the Mute and Volume up buttons.
2. Press and hold the Volume Up button and power on the device.
3. Release the Volume Up button when the
press the Mute button.
Wait while the video system reverts to the default factory settings. The
video system restarts automatically when finished. This may take a few
minutes.
When the system has been successfully reset to factory settings, the
Setup assistant starts and you will see the Welcome screen. Refer to
the DX80 Getting Started guide for details.
Factory reset DX80 using the reset button
To use this method, the DX80 must be up and running.
1. Flip the connector cover up to uncover the connector panel at the rear
of the video system.
2. Use the tip of a pen (or similar) to press the recessed reset button.
Hold the button for 1-2 seconds, until a notification Resetting to factory
settings shows on screen.
3. Wait while the video system reverts to the default factory settings. The
video system restarts automatically when finished. This may take a few
minutes.
When the system has been successfully reset to factory settings, the
Setup assistant starts and you will see the Welcome screen. Refer to
the DX80 Getting Started guide for details.
D15362.02 DX70 and DX80 Administrator Guide CE8.3, JANUARY 2017.
Configuration Peripherals
(page 2 of 3)
Mute button is lit red, then
Maintenance Maintenance
Right side seen
from the front
Mute
Volume up
Reset button (pin hole)
The recessed button can be quite difficult to use.
You should feel the button go down when pushed.
54
Administrator Guide
System settings
Flip the connector cover up to
uncover the connector panel.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
Appendices