Conference Defaultcall Rate; Conference Donotdisturb Defaulttimeout; Conference Encryption Mode; Conference Farendcontrol Mode - Cisco DX70 Administrator's Manual

Cisco DX70 and DX80

Introduction

Conference DefaultCall Rate

Define the Default Call Rate to be used when placing calls from the system.
Requires user role: ADMIN
Default value: 3072
Value space: Integer (64..3072)
The default call rate (kbps).

Conference DoNotDisturb DefaultTimeout

This setting determines the default duration of a Do Not Disturb session, i.e. the period
when incoming calls are rejected and registered as missed calls. The session can be
terminated earlier by using the user interface. The default value is 60 minutes.
Requires user role: ADMIN
Default value: 60
Value space: Integer (1..1440)
The number of minutes (maximum 1440 minutes = 24 hours) before the Do Not Disturb
session times out automatically.

Conference Encryption Mode

Define the conference encryption mode. A padlock with the text "Encryption On" or
"Encryption Off" displays on screen for a few seconds when the conference starts.
NOTE: If the Encryption Option Key is not installed on the video system, the encryption
mode is always Off.
Requires user role: ADMIN
Default value: BestEffort
Value space: Off/On/BestEffort
Off: The system will not use encryption.
On: The system will only allow calls that are encrypted.
BestEffort: The system will use encryption whenever possible.
> In Point to point calls: If the far end system supports encryption (AES-128), the call will
be encrypted. If not, the call will proceed without encryption.
> In MultiSite calls: In order to have encrypted MultiSite conferences, all sites must
support encryption. If not, the conference will be unencrypted.
D15362.02 DX70 and DX80 Administrator Guide CE8.3, JANUARY 2017.
Configuration Peripherals Maintenance

Conference FarEndControl Mode

Lets you decide if the remote side (far end) should be allowed to select your video sources
and control your local camera (pan, tilt, zoom).
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The far end is not allowed to select your video sources or to control your local
camera (pan, tilt, zoom).
On: Allows the far end to be able to select your video sources and control your local
camera (pan, tilt, zoom). You will still be able to control your camera and select your
video sources as normal.

Conference FarEndControl SignalCapability

Define the far end control (H.224) signal capability mode.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: Disable the far end control signal capability.
On: Enable the far end control signal capability.

Conference MaxReceiveCallRate

Define the maximum receive bit rate to be used when placing or receiving calls.
Note that this is the maximum bit rate for each individual call; use the Conference
MaxTotalReceiveCallRate setting to set the aggregated maximum for all simultaneous active
calls.
Requires user role: ADMIN
Default value: 3072
Value space: Integer (64..3072)
The maximum receive call rate (kbps).
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
66
Administrator Guide
System settings System settings Appendices