Cables - XBody Newave User Manual

The power supply unit is placed inside the bottom part of the leg, therefore it is part of the device. If
the switch on the leg is set to state 0 the device cannot be started because the device is not under
electricity.
This is the last step of the machine assembly.
Note: Let the assembled XBody Newave settle to the ambient temperature of the training
environment to assure best start-up responses to the introduction of electrical power.
4.2

Cables

The spiral cable is manufactured by XBody Hungary LLC and is uniquely identified. It contains an NFC
chip which carries the same information as the labeling on the housing of the connector. It states the
type of the cable and the date of manufacturing. This cable must be connected to the cable whip
contained in the XBody Training Suit.
Important: If the cable becomes disconnected either before or during training, turn off the
stimulation, reconnect the cables, and then resume the training session.
On/Off button on the back of the head
User Manual
Version: 1.7
Page: 12 / 47