XBody Newave User Manual page 12

User Manual
Version: 1.7
On the upper part of the leg you can find to pins which guide putting the head element into the right
place. Before fitting the head to the leg, the power supply cable has to be attached into the
connector on the bottom of the head. After that, the head can be placed with an easy downward
pressure (see figure below). Note: The head can only be plugged into the power supply cord that is
inside the leg. Do not connect it to another power source. The device falls into the Type BF
classification. The training suit including the cabling and electrodes is classified as applied part thus
the client has to be in physical contact with these parts during the training.
Placing the head on the leg
On the back side of the head you can find an On/Off button, a USB port and a parallel port. Only an
XBody USB drive can be plugged into the device, which is provided by XBody Hungary LLC. With the
help of the USB drive, the training statistics can be exported. The parallel port provides an interface
for the spiral cable thus it is responsible for the connection between the machine and the suit. The
machine connector of the spiral cable should be put into the parallel port and it must be fixed with
the pin connection on the cable housing. The free end of the spiral cable can be hanged on the
fixture provided on the side of the leg just below and to the left of the primary spiral cable interface.
USB and parallel port
In order to switch on the device use the On/Off button on the back of the head and the machine will
be ready to use.
Page: 11 / 47