Introduction; Features - Salus EP110 Installation Manual

Introduction

A programmable heating controller is used to switch the heating system and/or hot water in your home as
needed. It works by controlling the heating boiler according to a series of programmed settings that take effect
at different times of the day. The controller can be set up to 3 programs per day, with complementary Boost
actions and can operate in five different modes. Three different sets of time can be set for each day of week,
resulting in a total of 21 settings applicable to the device.
When connected to a system with a non-programmable (digital) thermostat, it can switch off/on the boiler
and control the heating and/or hot water in your system in a programmed manner. You can use the controller
in a fully pumped and controlled system, where heating and hot water can be operated independently or in
gravity-fed water system, where the central heating cannot be operated without hot water.
The heating system will not work if the programmer has switched it off. The controller does not detect the
temperature or adjust the heating mode in your house, it just tells the boiler when to switch Off/On depending
on our individual time settings.
With the controller you don't have to worry about switching On/Off your system manually. All you need to do
it so set up the schedules that fit your needs. The controller can be used on your system to control either the
central heating OR the hot water.

Features

• Single Channel Programmer for Central Heater or Hot Water
• 12 or 24 hour clock format
• 5+2 or 24 h individual program with 3 settings per day
• Boost function
• Holiday function
• Advance function
• Memory backup
04 EP110 Installation Manual