Salus EP110 Installation Manual page 10

Operating Modes
EP110 can operate in 5 different modes, described in the table below. EP110 can be set to control either the
boiler OR the hot water. You can choose on which one of the channels you connect the controller. To access
operating modes, please press Mode key.
Operation Mode
ON
ONCE
AUTO
ADV
OFF
For activating the functions described above, press the MODE button. The operating mode is cycled in
the below sequence:
ON Mode
MODE
SELECT
ONCE Mode
MODE
SELECT
10 EP110 Installation Manual
Pressing the Mode key once activates the ON Mode. In ON mode, the
controller gives the boiler the ON command, so the heating or the hot
+Hr
water will run continuously.
The circle icon
SET
output is ON.
Pressing the Mode key twice activate the ONCE Mode. In ONCE mode, the
+Hr
controller gives the boiler the command to run only for one period per
day (from program 1 ON to program 3 OFF)
SET
Function
Continuously on
On for 1 period a day, from Program 1 ON to Program 3 OFF
Automatic program control
When device is in Auto or Once mode, press the MODE
button for 3 sec for selecting Advance (ADV). This will move
the unit into the next program. When the ADV function
ends the device will return to normal program.
Continuously off
will be rotating in a sequence when the relay