Salus EP110 Installation Manual page 6

Wall mounting
Fix the backplate to the wall.
Jumper settings
The jumpers are found on the rear of your controller and can be used
to change the settings for the program type or internal backup memory
battery. If you want to change the position of your jumpers, please note
that you will need to reset your device. The default position for the jumpers
set a 5+2 program type and keep the internal backup battery off.
Switch
Program
Memory Backup
Note: Changes to the jumper settings should only be made by the engineer carrying out the installation
or another qualified person. The installer should select the jumper positions required if changes need to
be made to the factory default settings. These jumpers are found on the rear of the controller.
06 EP110 Installation Manual
Align the front housing
at the top edge.
EP110 Switching Bridges
Feature
5-2 days program or
24h program
Disable/enable the
internal backup
battery
Fit the front housing. Press lightly.
Setting
5-2 24H
OFF ON
Default
5-2 days program
Internal backup
battery disabled