Advertisement
1. Connect the correct camera plugs to the 360º module. Front, rear, left side, right side, CVBS and CVBS
RV.
2. The CVRS output is video output controlled by the power on/off button to the system. It is connected
to the AUX video input on the aftermarket radio/display.
3. The CVRS RV output is video output when the accessory is powered on. It is connected to the back-up
camera input on the aftermarket radio/display.
4. If not done so yet connect the power harness to the 360º module. Wire up the power connections,
yellow is constant, red is accessory, black is ground, blue is reverse.
5. Do not mount the 360º module; you will need to get to it for calibration of the cameras.
6. Plug in the Key Box and mount to the right side of the steering column on the dash trim with the tape
provided. (Or any place that is flat and within reach of the driver.)
7. To turn on the system press the power button on the Key Box. To change camera views press the car
image button. A long press will show a full front view another long press will show a full rear view.
8. Place the vehicle into reverse to see the rear camera image on the screen. Or turn on screen to see
image. (Warning will be displayed on the screen until the unit is calibrated.)
AVMS-3690 Instructions 9-2-16
Section 4:
360º module installation
Page 8 of 9
INSTALLATION INSTRUCTIONS
Advertisement
