Advertisement
8. With the sticker still in place, drill the (2) mounting screw holes with a 1/16 drill bit. ( Do not go all the
way though .)
9. The side cameras, brackets and pods are labeled for right-RH and left-LH. Make sure to assemble them
correctly. Use caution not to loss the tiny screws to mount the cameras to the brackets and the
brackets to the pods.
10. Using the LH camera assembly, attach the foam gasket to the bottom side of the pod, lining up the
notch in the foam with the bump on the pod.
11. Adjust the side cameras so that at least 3 feet beyond the front and rear bumper is shown in the
image. Mount the 4 cameras in the acceptable range of positions, or the calibration of the images
might not be possible.
12. The Camera images can be viewed on the monitor by connecting the ECU to the Calibration KIT.
13. The view mode can be changed in order of Front, Rear, Left and Right by pressing the view button on
the Key box.
14. Remove the tape from the foam gasket and mount the camera pod to the mirror. Use the self-tapping
screws provided to mount the pods to the underside of the mirror. ( Do not over tighten the screws; it
may strip out the plastic.)
AVMS-3690 Instructions 9-2-16
INSTALLATION INSTRUCTIONS
Page 6 of 9
Advertisement
