Advertisement
3. Make sure the template is to at least the middle to outer edge of the mirror. ( The camera needs to see
only 10% of the side of the vehicle and mainly the ground and objects next to the vehicle .)
4. Remove the door panel and the nuts or screws that are holding the mirror to the vehicle.
5. Place the mirror on a soft or padded surface and remove the glass from the mirror. ( Each vehicle is
different, but most are mounted by a center circle and will unclip from it .)
6. After the glass is removed, check to see if where the templates are placed there is clearance for the
camera and will not cut into anything in the mirror housing. ( If the template has to be moved make
sure to keep the arrow aiming the same way .)
7. Drill a hole in the bottom of the mirror using a hole saw or Uni-bit to the size on the template. Which is
1 1/8"
AVMS-3690 Instructions 9-2-16
INSTALLATION INSTRUCTIONS
Page 5 of 9
Advertisement
