Danfoss DHP-iQ Installation Manual page 8

Installation Guide
Warning
Warning
Warning
Warning
Warning
Caution
Caution
Caution
Caution
8
DHP-iQ
Always remember to inspect the unit, electric connections, refrigerant
tubes and protections regularly. These operations shall be performed
by qualified personnel only.
The unit contains moving parts and electrical parts, which should al-
ways be kept out of the reach of children.
Do not attempt to repair, move, alter or reinstall the unit by unauthor-
ized personnel, these operations may cause product damage, electric
shocks and fires.
Do not touch the internal parts (water pipes, refrigerant pipes, heat ex-
changers, etc) while running the units. And if you need to adjust and
touch the units, have enough time for the unit to be cooled off and be
sure to wear protective gloves.
In case of refrigerant leakage, try to avoid getting in contact with the
refrigerant because this could result in severe wounds.
Inspect the product shipped and check if damaged during transport. If
the product has some damages, DO NOT INSTALL and immediately
discuss about the damages with the carrier or retailer (if the installer or
the authorized technician has collected the material from the retailer.)
Always make sure that the power supply is compliant with local safety
standards.
Install the power cable and communication cable of the indoor and
outdoor unit at least 1m away from the electric appliance.
Protect the unit from rats or small animals. If an animal makes a con-
tact with the electric parts, it can cause malfunctions, smoke or fire.
Please instruct the customer to keep the area around the unit clean.
VIJSS102 Danfoss Heating Solutions