Siemens GIGASET SL55 Manual page 17

Setting up the base station – Getting started wizard
Operation on a PABX
Only carry out the following steps if you want to connect your telephone to a private
PABX (not directly to the NTBA). Depending on the PABX, it may be necessary for you to
enter an access code (outside line code) for external calls during installation; refer to the
operating instructions for your PABX for details. You can enter an access code (one to
four digits).
The display shows: Operate behind PABX?
[RRRRRRRRRRRRRRRRRRRRRRRRRRR]
YES
[RRRRRRRRRRRRRRRRRRRRRRRRRRR]
YES
~
Í
s s
/ Save entry
The display shows Installation completed. Press the End call key a, to return the hand-
set to idle status.
16
Press the display key to confirm the prompt.
Press the display key to confirm the Set access
code? prompt.
Entering the access code (outside line code)
Press the display key to open the submenu.
Select and confirm. The Getting started wizard is
OK
closed.