Siemens GIGASET SL55 Manual page 13

Setting up the base station – Getting started wizard
Example of how to assign an MSN:
You have requested four MSNs, two for business use (MSN1, MSN2) and two for private
purposes (MSN3, MSN4). Four handsets are connected to a base station. Two handsets
(Int.11 and 12) and the answering machine AM 91 are intended for business use, and
two handsets (Int.13 and 14) and the answering machine AM 92 are intended for pri-
vate use.
Internal subscribers
Handsets
Answering
machine
Handset
Handset
Answering
machine
Because internal 11 and internal 12 handsets are each assigned two (receive) MSNs,
they can use the MSN next call feature (page 68). They can switch to (send) MSN2 dur-
ing each outgoing external call. In this example, the internal 13 and 14 handsets cannot
do this.
Launching the Getting started wizard and making the basic settings
¢
v w Ð
/
[RRRRRRRRRRRRRRRRRRRRRRRRRRR]
YES
~
OK
◆
◆
i
◆
◆
12
Use
Int.11, 12 Business
AM 91
Int.13 Private
Int.14
AM 92
¢ ¢
Base Installation
Press the display key to launch the Getting started
wizard.
If you already have set a system PIN (not 0000)
(page 61), you will be asked to enter it.
If required, enter the system PIN and confirm.
The Getting started wizard cannot be used simultaneously by multiple
handsets.
If the settings already contain data (factory defaults or previous
settings), this data is shown at the appropriate positions in the display
and can be modified there.
To cancel the Getting started wizard, press and hold the End call key.
All changes you have already saved using Save entry
The handset returns to idle status.
To skip a setting, press the
Receive MSN
MSN1, MSN2
MSN1, MSN2
MSN3
MSN4
MSN3, MSN4
display key.
§NO§
Send MSN
MSN1
---
MSN3
MSN4
---
are retained.
§OK§