Diverting An Incoming Call - Cd (Call Deflection); Transferring Calls - Siemens GIGASET SL55 Manual

Functions during a call
Establishing a conference call
You are making an enquiry call. The first subscriber is put on hold.
Press the display key to establish a conference call.
CONF.
Ending a conference call
You have several options for ending a conference call:
either ...
a
or ...
[RRRRRRRRRRRRRRRRRRRRRRRRRRR]
INDIV.
Diverting an incoming call – CD (Call Deflection)
CD enables an incoming call to be diverted to any phone number while it is ringing,
without having to answer the call.
You can pre-set a diversion destination (page 72), dial a phone number from the direc-
tory or enter a new number.
v v
/
s s
/ Forward

Transferring calls

Transferring a call to an external number – ECT (Explicit Call Transfer)
Requirements:
The feature must be activated see page 79.
◆
Call transfer is only possible if the exchange or your ISDN PABX also supports ECT.
◆
If not, the external call is ended. The number cannot be called back.
To "hold" when making an enquiry call from an external call, Ext. enq. call must be
◆
set (page 74).
You are making an external call and would like to transfer it to another external sub-
scriber. Establish an external enquiry call (page 25) and press the End call key a
(also before answer), to transfer the call.
With some ISDN PABX systems, your two parties are not connected to one
i
another when you press the End call key during a transfer. In this case you
should activate this function on your ISDN PABX, if possible.
28
You end the conference:
Hold down (return to idle status).
You change the conference to an enquiry call:
Press the display key to change the conference call to
an enquiry call (page 25 or page 26).
The connection that was active immediately before
the conference call was established becomes the
active call again.
Open menu.
Select and confirm.
OK
The preset diversion destination is dialled.