Handset does not ring.
1.
The ringtone is switched off.
Activate the ringtone.
◆
2.
Call diversion set to All Calls.
Switch off call diversion.
◆
3.
MSN is not assigned to internal subscriber or is incorrect.
Specify receive MSN (page 67).
◆
Handset does not ring after setting up the ISDN number (MSN).
The area prefix has been stored with the MSN.
Store MSN without area code.
◆
Some of the ISDN functions do not work as specified.
ISDN functions are not enabled.
Check with your network provider.
◆
The display shows "Not possible!".
Check telephone cable connection between base station and NTBA.
◆
Call charges are not being displayed.
1.
Your network provider does not support this feature.
2.
There are no units.
Ask your network provider to transmit the units.
◆
3.
Charge per unit is set to "00.00".
Set the charge per unit (page 49).
◆
The caller's number is not displayed.
Calling line identification is not enabled.
Caller should ask their network provider to activate calling line identification
◆
(CLIP).
You hear an error tone (descending tone sequence) when inputting.
Action has failed/invalid input.
Repeat the operation.
◆
Watch the display and refer to the operating instructions if necessary.
For call diversion, the divert conditions are not displayed.
Internal call diversion is activated.
Activate external call diversion.
◆
Ask your network provider to enable this feature.
◆
On a PABX, dialling results in no connection or an incorrect connection.
The access code has not been entered or has been entered incorrectly.
Check and correct the access code (page 79).
◆
The caller list does not indicate a time for a message.
Date/time are not set.
Set the date/time (page 13).
◆
Appendix
97