Setting Reset Times - Avaya G350 Administration

To determine the result of the
the following output:
•
Registered — indicates whether or not the G350 is registered with an MGC (YES or NO).
•
Active Controller — displays the IP address of the active MGC. If there is no active MGC (i.e.,
if the
set mgc list
•
H248 Link Status — indicates whether the communication link between the G350 and the MGC
is up or down.
•
H248 Link Error Code — if there is a communication failure between the G350 and the MGC,
this field displays the error code.
To show the current MGC list, use the
of the MGCs on the MGC list.
To remove one or more MGCs from the MGC list, use the
of the MGC you want to remove as an argument to remove that MGC. You can remove more than one
MGC with one command by typing the IP addresses of all the MGCs you want to remove, separated by
commas. To remove all the MGCs on the list, use the
To change the G350's MGC list:
1
Use the
2
Use the
NOTE:
If you use the
adds the new MGCs to the end of the MGC list.

Setting reset times

If the connection between the G350 and its registered MGC is lost, the G350 attempts to recover the
connection. Use the
command to set the time-out for the G350's search for the primary MGC and the other MGC's on its
MGC list, respectively. Use the
which the primary MGCs in the list end and the LSPs begin. For example, if there are three IP addresses
in the MGC list and the third address is the LSP, the transition point should be 2.
The default time for the primary search is 1 minute. The default time for the total search is 30 minutes.
The default transition point is 1.
For example:
G350-001> set reset-times primary-search 20
G350-001> set reset-times total-search 40
350-001> set reset-times transition-point 1
In this example, in the event of a loss of connection with the registered MGC, the G350 searches for the
primary MGC on its MGC list for 20 minutes. If the G350 does not establish a connection with the
primary MGC within this time, it searches for the other MGCs on the list for a total of 40 minutes.
Use the
show recovery
Administration of the Avaya G350 Media Gateway
June 2004
set mgc list
command failed to configure an MGC), this field displays 255.255.255.255.
show mgc list
command with no arguments to clear the MGC list.
clear mgc list
command with a different set of IP addresses.
set mgc list
command without first clearing the MGC list, the G350 simply
set mgc list
set reset-times primary-search
set reset-times transition-point
command to show the status of MGC and ICC monitoring and recovery setup.
Configuring the Media Gateway Controller (MGC)
command, use the
show mgc
command. This command shows the IP addresses
clear mgc list
command with no arguments.
clear mgc list
command and the
command to configure the point at
Basic device configuration
command. This command has
command. Type the IP address
set reset-times total-search
43