Basic Device Configuration; Defining An Interface - Avaya G350 Administration

4

Basic device configuration

This chapter provides information about basic configuration of the Avaya G350 Media Gateway and
contains the following sections:
•

Defining an interface

•
Configuring the Primary Management Interface (PMI)
parameters that identify the G350 to other devices
•
Defining the default gateway
default gateway
•
Configuring the Media Gateway Controller (MGC)
to work with the G350
•
Viewing the status of the device
•
Version management
configuration, and other files on the G350
Defining an interface
In a new Avaya G350 Media Gateway, only the console and USB interfaces are defined. All other
interfaces must be defined by the administrator, after installation of the G350.
To define an interface:
1
Use the
identifier as a parameter. Other types of interfaces require the interface's module and port number
as a parameter. For example:
interface vlan 1
interface serial 2/1
For more information on the various types of interfaces, see
page 134.
2
Use the
to the interface.
3
Use the
4
For a list and descriptions of other interface configuration commands, see
on page 134. For interface configuration examples, see
Administration of the Avaya G350 Media Gateway
June 2004
— instructions on how to define a new interface and its IP address
— instructions on how to define a G350 interface as the G350's
— instructions on how to view the status of the G350
— instructions on how to manage and upgrade software, firmware,
command to enter the interface context. Some types of interfaces require an
interface
command, followed by an IP address and subnet mask, to assign an IP address
ip address
command to set the load calculation interval for the interface.
load-interval
Basic device configuration
Defining an interface
— instructions on how to configure
— instructions on how to configure an MGC
Router interface concepts
Configuring interfaces
WAN configuration example
on
on page 85.
39