Auto Takeoff And Auto Landing; Starting/Stopping The Motors (When Using Remote Controller) - dji Spark User Manual

Spark User Manual

Auto Takeoff and Auto Landing

Auto Takeoff
Use auto takeoff only if the Aircraft Status Indicators are blinking green. Follow the steps below to use the
auto takeoff feature:
1. Launch the DJI GO 4 app, and tap "GO FLY" to enter camera page.
2. Complete all steps on the pre-flight checklist.
3. Tap " ", and confirm that conditions are safe for flight. Slide the icon to confirm and takeoff.
4. Aircraft takes off and hovers at 1.2 meters above ground.
Aircraft Status Indicator blinks rapidly when it is using the Vision System for stabilization.
The aircraft will automatically hover below 30 meters. It is recommended to wait until there is
sufficient GPS before using the Auto Takeoff feature.
Auto-Landing
Use auto-landing only if the Aircraft Status Indicators are blinking green. Follow the steps below to use
the auto-landing feature:
1. Tap on , to ensure the landing condition is ideal. Slide to confirm.
2. Abort landing process immediately by using the
3. Aircraft will land and turn off automatically.

Starting/Stopping the Motors (When Using Remote Controller)

Starting the Motors
The Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom
inner or outer corners to start the motors. Once the motors have started spinning, release both sticks
simultaneously.
Stopping the Motors
There are two methods to stop the motors.
Method 1: When the aircraft has landed, push and hold the left stick down. The motors will stop after three
seconds.
Method 2: When aircraft has landed, push the left stick down, then conduct the same CSC that was used
to start the motors, as described above. Motors will stop immediately. Release both sticks once motors
stop.
Method 1
48
©
2017 DJI All Rights Reserved.
button on the screen.
OR
OR
Method 2