Auto Takeoff And Auto Landing; Starting/Stopping The Motors - dji MATRICE 200 Series User Manual

Auto Takeoff and Auto Landing

Auto Takeoff
Use auto takeoff only if the Aircraft Status Indicators are blinking green. Follow the steps below to
use the auto takeoff feature:
1. Launch the DJI GO 4 app and tap GO FLY to enter Camera View.
2. Complete all steps on the pre-flight checklist.
3. Tap" ", and confirm that conditions are safe for flight. Slide the icon to confirm and takeoff.
4. Aircraft takes off and hovers at (1.2 meters) above ground.
Aircraft Status Indicator blinks rapidly when it is using the Vision System for stabilization.
The aircraft will automatically hover below 10 meters. It is recommended to wait until there
is sufficient GPS lock before using the Auto Takeoff feature.
Auto-Landing
Use auto-landing only if the Aircraft Status Indicator is blinking green. Follow the steps below to use
the auto-landing feature:
1. Tap , to ensure that landing conditions are ideal. Slide to confirm.
2. Abort landing process immediately by tapping
3. a. When Landing Protection determines that the ground is suitable for landing, the aircraft will
land gently.
b. If Landing Protection determines that the ground is not suitable for landing, the aircraft will
hover and wait for pilot confirmation.
c. If Landing Protection is not operational, the DJI GO 4 app will display a landing prompt when
the aircraft descends below 0.7 meters. Pull down on the throttle or use the auto landing slider
to land.
4. The aircraft will land and turn off automatically.

Starting/Stopping the Motors

Starting Motors
The Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom
inner or outer corners to start the motors. Once the motors start spinning, release both sticks simul-
taneously.
Stopping the Motors
There are two ways to stop the motors:
1. When aircraft has landed, push the left stick down
to start the motors, as shown above
motors stop.
on the screen.
OR
, then conduct the same CSC that was used
. Motors will stop immediately. Release both sticks once
MATRICE 200 SERIES User Manual
©
2018 DJI All Rights Reserved.
73