Gesture Mode - dji Spark User Manual

Gesture Mode

Deep learning gesture recognition allows you to take selfies with simple hand motions. Spark features
brand new gesture controls like PalmLaunch, PalmControl, PalmLand, Beckon, and Selfie. It is highly
recommended to install the Spark Propeller Guards before using Gesture Mode to ensure safety.
Feature Descriptions
PalmLaunch
1. Power on the aircraft while holding it. Wait for
the aircraft status indicators to blink yellow.
Make sure your fingers are well below the
aircraft arms.
2. Next, tap the Intelligent Flight Battery power
button twice. The front LEDs should blink yellow
slowly.
3. FaceAware will start to work automatically.
When FaceAware activates successfully,
the aircraft beeps twice and the front LEDs
become solid green. If the front LEDs blink
red twice, then FaceAware has failed. Please
repeat step 2.
4. The front LEDs will glow solid red after the
motors start spinning. Release the aircraft and it
will hover in place.
Start/Stop PalmControl
1. Stand in front of the aircraft, then raise and
extend one of your arms in the direction of
the aircraft. Extend your fingers and keep
them close together. Position your palm
about 0.7 m in front of the aircraft's nose for
about two seconds.
2. The front LEDs will glow solid green if the
PalmControl activation is successful. Adjust
your distance from the aircraft if the front LEDs
start to blink yellow fast. This means you are too
close or too far away from the aircraft.
3. Dropping your hand quickly will exit
PalmControl, and the front LEDs should glow
solid red.
Front LEDs
—— Solid red
Blinks yellow
—— Solid green
—— Solid red
—— Solid green
—— Solid red
Spark User Manual
Figure
©
2017 DJI All Rights Reserved.
23