dji Spark User Manual page 29

Charging the Intelligent Flight Battery
1. Connect the Battery Charger to a power source (100-240 V, 50/60 Hz).
2. Connect the Micro USB port on Spark to the charger to start charging.
3. The Battery Level Indicator will display the current battery level as it is charging.
4. The Intelligent Flight Battery is fully charged when the Battery Level Indicators are all off. It will take
approximately 1 hour and 20 minutes to fully charge the battery. Detach the charger when the battery
is fully charged.
Never insert or remove a battery when it is turned on.
Allow battery temperature to drop to room temperature before storing for an extended period.
The charger will stop charging the battery if battery cell temperature is not within the operating
range (5°C to 40°C).
LED1 LED2
Battery Protection LED Display
The table below shows battery protection mechanisms and corresponding LED patterns.
LED1 LED2 LED3
LED3 LED4
LED4 Blinking Pattern
LED2 blinks twice per second
LED2 blinks three times per second Short circuit detected
LED3 blinks twice per second
LED3 blinks three times per second Over-voltage charger detected
LED4 blinks twice per second
LED4 blinks three times per second Charging temperature is too high
Charger
Power Outlet
Battery Level
50%~75%
75%~100%
Fully Charged
Battery Protection Item
Over current detected
Over charge detected
Charging temperature is too low
Spark User Manual
0%~50%
©
2017 DJI All Rights Reserved.
29