Table of Contents
Advertisement
After installation of the printer, you can print actual samples using sample slicing file(G-code) enclosed in SD
memory card.
It is recommend that you read the instruction manual enclosed in SD card or downloadable from
home page (www.3dcubicon.com), before moving onto actual printing process.
① Hang a filament spool into printer's spool holder,
and then push the filament through Teflon tube
into inlet hole of the printer.
③ To Load the filament into the extruder, please refer to the picture below.
If you push [OK] at Home screen, you may get access to the function menu. (please refer to user manual for
more details)
[HOME] > [OK]
As filament type inside the nozzle is unclear, temperature
inside printer is normally set 240degree Celsius.
Load the filament long enough to get 1m filament from nozzle.
During loading process, you would often get other colors and
types of filament extruded.
Copyright Reserved HyVISION System Inc.
This document is Quick Start Guide (151001,En). To improve quality of product, this could be revised without
prior notification or consent.
HyVISION System is not liable for any losses resulted from the use of the document or any errors or offering.
Print for the first time (1/2)
② Switch on the printer power.
*The number changes according to ambient temperature.
If LCD scren shows that "Cubicon Ready"
turns to "Check SelfTestResult", it is an
indication that there is an error in main
component inside printer.
happens, please do not start the operation of the
printer until you make sure to check the
components indicated as fail in Function Menu
{Configuration>SeftTest Result} * In case that self-
remedy seem difficult, please contact nearest After
Service Center.
When this
13
Advertisement
Table of Contents
