Cubicon Style 3DP-210F Quick Start Manual page 6

E1
E2
E3
E4
E5
[E1] Filament insertion hole
[E2] Filament handle
[E3] Mold fan
[E4] Heated block cover
[E5] Nozzle
[E6] Extruder cable
[E7] Cable fixing screw
[E8] Cable fixing block
[E9] Cool End fan
[E10] Extruder module fixing screw
[E11] Gear fan
[E12] Extruder cover
* Do not touch the nozzle of extruder being heated while printing.
* Varify if there is some obstacles under the extrder when opening the Extruder cover.
* Remove or mount the Extruder module when the nozzle temperature cools down and power
turns off.
Copyright Reserved HyVISION System Inc.
This document is Quick Start Guide (151001,En). To improve quality of product, this could be revised without
prior notification or consent.
HyVISION System is not liable for any losses resulted from the use of the document or any errors or offering.
E6
E7
E8
E9
Hole to insert the filament into the Extruder through Teflon tube.
Handle to manually pull the filament out of the extruder or insert it.
Fan to flow the air into the molded object.
Cover case to surround the nozzle heated block. (heat-resisting rubber)
Nozzle to extrude the molten filament.
Cable for power supply of Extruder and signal transfer
Screw to fix the cable to the Extruder (m2.5)
Block to fix the cable to the Extruder.
Fan to cool down the heated block.
Fixing screw to separate the Extruder module.
Fan to cool down the gear of internal Extruder.
Cover to check the internal Extruder
Part of the Extruder
E12
E10
E11
6