Cubicon Style 3DP-210F Quick Start Manual page 5

1
2
3
4
[1] Teflon tube
[2] Extruder
[3] Clean filter case
[4] Heated Bed
[5] Internal LED ambient light
Heated Bed
[B1] Nozzle cleaning brush
[B2] Bed position fixing Pin
(3 spots)
[B3] Level point (3 spots)
Do not touch the nozzle of extruder and heated bed being heated up while printing.
Copyright Reserved HyVISION System Inc.
This document is Quick Start Guide (151001,En). To improve quality of product, this could be revised without
prior notification or consent.
HyVISION System is not liable for any losses resulted from the use of the document or any errors or offering.
Internal Parts and Heated Bed
B1
5
Path to feed the filament into the Extruder. (Be cautious not to bend it)
The part to move and extrude the molten filament.
The part to mount the clean air filter.
Bed platform to print out the object.
LED light to show the internal status of the printer.
Brush to clean the nozzle end at the beginning of the printing. (Heat resistant
rubber)
Pin to position of heated bed.
* Please make sure the pin is mounted at 3 spots on the bed.
Point to check the bed leveling.(Uncoated 3 spots)
* Please be clean on these 3 spots because Auto Leveling fails with the
contaminants on 3 spots.
B3
B2
5